Skip to main content

Commands

RemapIDs provides the /remapids id command to help you look up registry IDs for blocks and items in-game. This is useful when building remap configs, since you need to know the exact namespaced IDs.

/remapids id block​

Displays the registry ID of the block you are looking at.

Usage: Point your crosshair at a block and run /remapids id block

Output:

  • Block: minecraft:stone — the full registry ID of the targeted block
  • Block: minecraft:stone (Remapped from: oldmod:stone) — if an active remap targets this block
  • Block: oldmod:stone (Remaps to: minecraft:stone) — if this block is the source of an active remap
  • No block in range — if no block is within reach (5 blocks)

Permission: Any player can use this command (no operator level required).

/remapids id hand​

Displays the registry ID of the item in your main hand.

Usage: Hold an item and run /remapids id hand

Output:

  • Item: minecraft:diamond_sword — the full registry ID of the held item
  • Item: minecraft:diamond_sword (Remapped from: oldmod:diamond_sword) — if an active remap targets this item
  • No item in hand — if your main hand is empty

Permission: Any player can use this command (no operator level required).

Remap Information​

Both commands show active remap information when relevant:

  • Remapped from — This ID is the target of a remap. Something else redirects to it.
  • Remaps to — This ID is the source of a remap. It redirects to something else.

This helps you verify that your remap configs are working as expected and quickly identify which IDs are involved in remaps.

Use Cases​

Building remap configs​

When you need to find the exact registry ID of a block or item:

  1. Look at the block or hold the item
  2. Run /remapids id block or /remapids id hand
  3. Copy the registry ID into your remap config

Verifying remaps are active​

After creating a remap config and restarting (or running /reload for reloadable types):

  1. Find a block or item that should be remapped
  2. Run the identify command
  3. Check that the output shows the expected remap information